Asus TUF Z270 Mark 1 - Internal Connectors

30
ASUS TUF Z270 MARK 1 BIOS Manual
CPU Graphics Switching Frequency
The switching frequency will affect the CPU Graphics transient response speed and
the component thermal production.
Conguration options: [Auto] [Manual]
DO NOT remove the thermal module. The thermal conditions should be monitored.
The following item appears only when you set the CPU Graphics Switching Frequency to
[Manual].
Fixed CPU Graphics Switching Frequency(KHz)
This item allows you to set a higher frequency for a quicker transient
response speed. Use the <+> or <-> to adjust the value. The values range
from 250 KHz to 500 KHz with an interval of 50 KHz.
CPU Graphics Power Phase Control
This item allows you to set the power phase control of the CPU Graphics.
Conguration options: [Auto] [Standard] [Extreme] [Power Phase Response]
DO NOT remove the thermal module when setting this item to [Power Phase Response]
or
[Extreme]. The thermal conditions should be monitored. Boot Voltages
CPU Core/Cache Boot Voltage
Conguration options: [Auto] [0.600] - [1.700]
DMI Boot Voltage
Conguration options: [Auto] [0.3000] - [1.9000]
CPU System Agent Boot Voltage
Conguration options: [Auto] [0.7000] - [1.8000]
CPU VCCIO Boot Voltage
Conguration options: [Auto] [0.9000] - [1.8000]
CPU Standby Boot Voltage
Conguration options: [Auto] [0.700] - [2.200]
Internal CPU Power Management
The subitems in this menu allow you to set the CPU ratio and features.
Intel(R) SpeedStep(tm)
Allows the operating system to dynamically adjust the processor voltage and cores
frequency to decrease the average power consumption and decrease average heat
production.
Conguration options: [Auto] [Enabled] [Disabled]
Turbo Mode
Allows you to enable your processor cores to run faster than the base operating
frequency when it is below power, current and specication limit. Conguration options:
[Disabled] [Enabled]