Asus TUF Z270 Mark 1 - Page 56

56
ASUS TUF Z270 MARK 1 BIOS Manual
Ext. Fan(s) Configuration
ASUS FAN EXTENSION CARD is required to configure these items
Extension Fan 1-3 Q-Fan Control
[Disabled] Disable the Extension Fan Q-Fan control feature.
[DC mode] Enable the Extension Fan Q-Fan control in DC mode for 3-pin
extension fan.
[PWM mode] Enable the Extension Fan Q-Fan control in PWM mode for 4-pin
extension fan.
Extension Fan 1-3 Q-Fan Source
The assignment fan will be controlled according to the selected temperature source.
Conguration options: [CPU] [MotherBoard] [PCIEX16_1 Slot] [PCIEX16_3 Slot]
[VRM] [PCH] [T_SENSOR1] [EXT_Sensor1] [EXT_Sensor2] [EXT_Sensor3] [Multiple
Sources]
For EXT_Sensor1-3, connect a Thermistor cable to the EXT_TS1-3 header then place the
other end to the component to get the temperature.
Extension Fan 1-3 Fan Speed Low Limit
This item allows you to disable or set the extension fan warning speed.
Conguration options: [Ignore] [200 RPM] [300 RPM] [400 RPM] [500 RPM] [600 RPM]
Extension Fan 1-3 Profile
This item allows you to set the appropriate performance level of the extension fan.
[Standard] Set to make the extension fan adjust automatically depending on the
CPU temperature.
[Silent] Set to minimize the fan speed for quiet extension fan operation.
[Turbo] Set to achieve maximum extension fan speed.
[Manual] Set to assign the detailed fan speed control parameters.
ASST Fan Profile
This item allows you to set the appropriate performance level of the ASST Fan.
[Standard] Sets to [Standard] to make the chassis fan automatically adjust
depending on the chassis temperature.
[Silent] Sets to [Silent] to minimize the fan speed for quiet chassis fan
operation.
[Turbo] Sets to [Turbo] to achieve maximum chassis fan speed.
[Manual] Sets to [Manual] to assign detailed fan speed control parameters.