Asus TUF Z370-PLUS GAMING - DIGI+ VRM

3-16
Chapter 3: BIOS Setup
Chapter 3
CPU SVID Support [Auto]
Disabling SVID Support stops the processor from communicating with the external voltage
regulator. Conguration options: [Auto] [Disabled] [Enabled]
DRAM Timing Control
The subitems in this menu allow you to set the DRAM timing control features. Use the
<+> and <-> keys to adjust the value. To restore the default setting, type [auto] using the
keyboard and press the <Enter> key.
Changing the values in this menu may cause the system to become unstable! If this
happens, revert to the default settings.
DIGI+ VRM
CPU Load-Line Calibration
Load-line is dened by Intel VRM specication and affects the CPU power voltage.
The CPU working voltage will decrease proportionally depending on the CPU
loading. Higher levels of the load-line calibration can get a higher voltage and a better
overclocking performance but increases the CPU and VRM thermal. Select from level
1 to 7 to adjust the CPU power voltage from 0% to 100%. Conguration options: [Auto]
[Level 1] [Level 2] [Level 3] [Level 4] [Level 5] [Level 6] [Level 7]
The boosted performance may vary depending on the CPU specication. Do not remove
the thermal module.
CPU Current Capability
Allows you to congure the total power range, and extends the overclocking frequency
range simultaneously. Conguration options: [Auto] [100%] [110%] [120%] [130%]
[140%]
Choose a higher value when overclocking, or under a high CPU loading for extra power
support.
CPU VRM Switching Frequency
This item affects the VRM transient response speed and the component thermal
production. Select [Manual] to congure a higher frequency for a quicker transient
response speed. Conguration options: [Auto] [Manual]
DO NOT remove the thermal module. The thermal conditions should be monitored.
The following item appears only when you set the CPU VRM Switching Frequency to
[Manual].
Fixed CPU VRM Switching Frequency (KHz) [250]
This item allows you to set a higher frequency for a quicker transient
response speed. Use the <+> and <-> keys to adjust the value. The values
range from 250KHz to 500KHz with a 50KHz interval.