Asus TUF Z370-PLUS GAMING - CPU Power Duty Control

3-18
Chapter 3: BIOS Setup
Chapter 3
The GT power duty control adjusts the current and thermal conditions of every
component’s phase.
[T. Probe] Select to maintain the VRM thermal balance.
[Extreme] Select to maintain the current VRM balance.
CPU Graphics Power Phase Control
This item allows you to set the power phase control of GT. Conguration options:
[Auto] [Standard] [Extreme]
DO NOT remove the thermal module when setting this item to [Extreme]. The thermal
conditions should be monitored.
Internal CPU Power Management
The subitems in this menu allow you to set the CPU ratio and features.
Intel(R) SpeedStep(tm)
Allows the operating system to dynamically adjust the processor voltage and cores
frequency to decrease the average power consumption and decrease average heat
production.
Conguration options: [Auto] [Disabled] [Enabled]
Turbo Mode
Allows you to enable your processor cores to run faster than the base operating
frequency when it is below power, current and specication limit.
Conguration options: [Disabled] [Enabled]
The following three items appear only when you set the Turbo Mode to [Enabled].
Long Duration Package Power Limit
Allows you to limit the Turbo Ratio’s time duration that exceeds the TDP
(Thermal Design Power) for maximum performance. Use the <+> or <->
keys to adjust the value. The values range from 1 W to 4095 W.
Package Power Time Window
Also known as Power Limit 1, this item allows you to maintain the time
window for Turbo Ratio over TDP (Thermal Design Power). Use the <+> or
<-> keys to adjust the value. The values range from 1 to 127 in seconds.
Short Duration Package Power Limit
Also known as Power Limit 2, this item allows you to provide rapid
protection when the package power exceeds the Power Limit 1. Use the
<+> or <-> keys to adjust the value. The values range from 1 W to 4095 W.
IA AC Load Line [Auto]
This item allows you to set the AC loadline dened in 1/100 mOhms. Use the <+> and
<-> keys to adjust the value. Conguration options: [Auto] [0.01] - [62.49]
IA DC Load Line]
This item allows you to set the DC loadline dened in 1/100 mOhms. Use the <+> and
<-> keys to adjust the value. Conguration options: [Auto] [0.01] - [62.49]
Tweaker’s Paradise
The subitems in this menu allow you to set your motherboard congurations.
Realtime Memory Timing