2-4
Chapter 2: Setup
• To connect the HDMI/DisplayPort cable:
a. Plug one end of the HDMI/DisplayPort cable to the monitor’s HDMI/
DisplayPort jack.
b.
Connect the other end of the HDMI/DisplayPort cable to your device’s
HDMI/DisplayPort jack.
• To use the Service port for firmware upgrade: Save the new rmware to
the disk drive. Then plug the disk drive to the monitor’s Service port. Follow
the on-screen instructions to upgrade the rmware.
• To connect the power cord:
a. Connect the power adapter securely to the monitor’s DC input.
b. Connect one end of the power cord to the power adapter and the other
end to a power outlet.
2.6 Turning on the monitor
Press the power button . See
page 1-2
for the location of the power
button. The power indicator lights up in white to show that the monitor
is ON.
To Next Page
Loading...
