VivoMini VC65 Series
23
Installing 2.5” hard disk drive / solid state drive
To install or upgrade the hard disk drives / solid state drives:
1. Turn o your VivoMini then disconnect all cables and
peripherals.
2. Place the VivoMini on a at stable surface, with its top side
facing up.
3. Remove the screw from the top cover lock latch and push the
latch down (A and B), then slide the top cover towards the rear
of your VivoMini (C) until it is detached from the chassis.
4. Lift and remove the top cover (D) and set it aside.
5. Remove four (4) screws from the HDD/SSD bracket.
To Next Page
Loading...
