4
10. Place the rubber foot on each screw hole. Refer to the illustration for more details.
IMPORTANT! A number is printed under each rubber foot and this number corresponds
to that rubber foot’s location on the cover. Follow the orientation of each rubber foot
and the number sequence shown in the illustration below. The rubber foot ts in only
one orientation. Note the position of the hole on each rubber foot, as shown in the
illustration below
NOTE: If you want to remove the rubber foot, use a athead screwdriver or a
straightenedpapercliptodoso.
9. Reattach the screws to secure the cover back on the bottom side of the main box.
To Next Page
Loading...
