1-34
Chapter 1: Product Introduction
Chapter 1
15. RGB header (4-pin RGB_HEADER)
This connector is for RGB LED strips.
The RGB header supports 5050 RGB multi-color LED strips (12V/G/R/B), with a maximum
power rating of 2A (12V), and no longer than 2 meters.
Before you install or remove any component, ensure that the ATX power supply is switched
off or the power cord is detached from the power supply. Failure to do so may cause severe
damage to the motherboard, peripherals, or components.
• Actual lighting and color will vary with LED strip.
• If your LED strip does not light up, check if the RGB LED extension cable and the
RGB LED strip is connected in the correct orientation, and the 12V connector is
aligned with the 12V header on the motherboard. Make sure your LED stripe pins are
in the exact order (12V/G/R/B), for more details, please contact your product vendor.
To Next Page
Loading...
