2-52
Chapter 2: BIOS Setup
Fast Boot [Enabled]
[Disabled] Allows your system to go back to its normal boot speed.
[Enabled] Allows your system to accelerate the boot speed.
The following items appear only when you set the Fast Boot to [Enabled].
SATA Support [HDD Only]
[All Sata Devices] All devices connected to SATA ports are available during
POST. This process extends the POST time.
[HDD Only] Only hard drives connected to SATA ports are detected
during POST.
[Last Boot HDD Only] Only boot drives connected to a SATA ports are detected
during POST.
USB Support [Partial Initial]
[Disabled] All USB devices will not be available until OS boot up for a
fastest POST time.
[Full Initial] All USB devices will be available during POST. This process will
extend the POST time.
[Partial Initial] For a faster POST time, only USB ports with keyboard and
mouse connections will be detected.
PS2 Devices Support [Enabled]
Allows you to enable or disable control of the PS2 devices’ availability during POST.
Conguration options: [Enabled] [Disabled]
Network Stack Driver Support [Disabled]
[Disabled] Select to skip the network stack driver from loading during POST.
[Enabled] Select to load the network stack driver during POST.
Next Boot after AC Power Loss [Normal Boot]
[Normal Boot] Returns to normal boot on the next boot after an AC power loss.
[Fast Boot] Accelerates the boot speed on the next boot after an AC power loss.
DirectKey (DRCT) [Enabled]
[Disabled] Disables the DirectKey button. The system will only power on or off when
you press the DirectKey button.
[Enabled] Allows the system to power on and go to the BIOS Setup directly when you
press the Reset button. Connect the 2-pin connector of the chassis reset
buton cable to the onboard DRCT header.
To Next Page
Loading...
