Asus Z97-A/USB 3.1 - Network Stack Configuration; Create Raid Volume

ASUS Z97-A/USB 3.1
2-45
2.6.9 Network Stack Configuration
Network stack [Disable]
This item allows you to disable or enable the UEFI network stack.
Conguration options: [Disable] [Enable]
The following item appears only when you set the Network Stack to [Enabled].
Ipv4/Ipv6 PXE Support [Enabled]
This item allows you to enable or disable the Ipv4/Ipv6 PXE wake event.
Conguration options: [Disabled] [Enabled]
2.6.10 Intel(R) Rapid Storage Technology
Create RAID Volume
This item allows you to create a RAID volume.
This item only appears when at least one HDD is connected to the Intel
®
SATA ports and
set to RAID mode.
Name [Volume1]
This item allows you to key in a volume name for your RAID setup.
Use only alphanumeric characters for your RAID volume name. It should be 16 characters
or less.
RAID Level [RAID0(Stripe)]
This item allows you to select the RAID level.
Conguration options: [RAID0(Stripe] [RAID1(Mirror)] [RAID5(Parity)] [Recovery]
Select Disks
This item shows the connected SATA devices compatible for setting up RAID. On their
dropdown lists, select X to set up the RAID.
Strip Size: [32KB]
This item allows you to strip the size of your RAID setup.
Conguration options: [4KB] [8KB] [16KB] [32KB] [64KB] [128KB]
Capacity (MB): [0]
This item allows you to set the RAID capacity.