ASUS Z9PE-D8 WS 2-31
2.9.2 Internal connectors
1. Hard disk activity LED connector (4-pin HDLED1)
This LED connector is for the storage add-on card cable connected to
the SATA or SAS add-on card. The read or write activities of any device
connected to the SATA or SAS add-on card causes the front panel LED to
light up.
2. USB connectors (10-1 pin USB78, USB910; A-Type USB12/11)
These connectors are for USB 2.0 ports. Connect the USB module cables to
connectors USB78 and USB910, then install the modules to a slot opening at
the back of the system chassis. These USB connectors comply with USB 2.0
specication that supports up to 480 Mbps connection speed.
To Next Page
Loading...
