EN 16
INSTALLATION
Drilling the support surface and fitting the Hood
Important
The minimum distance between the opening for the hob and the
one for the hood must be of at least 3-5 cm according to the
strength of the material used for the working top.
Inserting the hood canopy into the support surface from above
• Insert the brackets 7.2, as indicated in the figure, into the slots
provided and fix them with the screws 12a provided.
• The hood is built ready for front installation of the motor unit.
• Insert the hood canopy into the cooker top, drilled as described
above.
• Centre the hood canopy with respect to the cooking hob slot.
• Fix the hood canopy with the 2 screws 12c provided.
109
812
To Next Page
Loading...
