EN 7
Cleaning filters
Saturation grease and carbon filters
The filters should be replaced or cleaned when the filter indicator is lit
or flashing.
Grease filter
The filter indicator will light up after 100 operating hours.
• The grease filters should then be cleaned.
Carbon filter
The filter indicator will flash after 200 operating hours.
• The carbon filter should then be replaced.
Reset the filter indicator
1. Switch off the cooker hood by pressing the on/off button.
2. Switch off the lighting by pressing the lighting button.
Reset the memory by quickly pressing the filter indicator button.
All indicators will flash three times.
If you have a cooker hood with a carbon filter, you should activate the
carbon filter indicator.
Switching on carbon filter indicator
1. Switch off the cooker hood by pressing the on/off button.
2. Press and hold the filter indicator button for approximately
5 seconds until all buttons flash twice.
The carbon filter indicator is activated.
Switching off carbon filter indicator
1. Switch off the cooker hood by pressing the on/off button.
2. Press and hold the filter indicator button for approximately
5 seconds until all buttons flash once.
The carbon filter buttons is deactivated.
USE
To Next Page
Loading...
Need help?
General
