GB 13
button, the timer function is activated for 15 minutes. After this time has
elapsed the hood will turn off (motor and any light on).
Indicator E
Lights indicator
The lights indicator will switch on when the lights are on at any level.
Indicator F
Filters indicator
After 30 minutes of operation, the led of the filters indicator will switch
on, not flashing indicating that the anti-grease filters have to be
washed. To reset the function (with the hood off), press the Fan speed
button for 5 seconds. After this operation, the led of the filters indicator
turns off and the setting of the 30 hours starts again from the beginning.
After 120 hours the led will flash continuously. This means that the
carbon filters have to be replaced (if present). To reset the function
(with hood off) press the Fan speed button for 5 seconds. After this
operation, the led of the indicator turns off and the setting starts again
from the beginning.
Indicator G
With the hood off, press the Power button (1) for 5 seconds to activate
the clean air function. This will switch on the motor at speed 1 for 10
minutes every hour. The light indicator will switch on without flashing
and the led of the 1st speed will switch on. In the remaining 50 minutes
the light indicator will flash. The function can be deactivated by
pressing any button except for the lights one.
USE
Controls
Button A
The on / off button switches on and off the whole hood (motor and
lights).
By pressing the button the motor starts at 1st speed.
Button B
From the OFF position, press once for the 1st speed, twice for the
2nd speed and three times for the 3rd speed. In order to activate the
intensive speed, press the button for 5 seconds regardless of the status
of the hood. For each speed only the led indicating the set speed will
turn on. The intensive speed is indicated by the flashing of the led
indicating speed 3. The duration of the intensive speed is 10 minutes;
after this time the hood goes back to the last set speed. In order to
remove the intensive speed press the power button and the hood will
switch off, or press the Fan speed button and the speed goes back to
the previously set one. Speed of the hood with cyclic trend.
Button C
Light
There are three light levels: high, medium, low.
From the off position press once for the high level, twice for the medium
level, three times for the low level and four times to turn the lights off.
The level of the lights has a cyclic trend: High, medium, low, off.
Button D
Timer
With any type of speed (excluding the intensive speed), by pressing the
To Next Page
Loading...
