EN 6
USE
Switching on the timer
• Switch on the extractor cap with button ‘A’.
• Set the extraction strength with buttons ‘B’ and ‘C’.
• Press the Timer button ‘F’.
The extractor cap switches off automatically after 30 minutes.
Switch off the Timer function by pressing button ‘F’ again, or by
switching off the extractor cap with button ‘A’. The display shows
the selected speed and the remaining time.
Grease filter indicator
After 100 hours of use the “F6” indicator is shown in the display.
• Clean the grease filters.
Carbon filter indicator
After 200 hours of use the “FC” indicator is shown in the display.
• Replace the carbon filters.
Reset the filter indicator alarm
• Turn the Lights and the motor off.
• Press button ‘E’ for 3 seconds.
To Next Page
Loading...
