Appendix
Troubleshooting
The charge light is off or blinking.
Make sure you plug the power and line cords in correctly
and securely.
Unplug the electrical power. Wait for 15 seconds, then plug it
back in. Allow up to one minute for the cordless handset and
telephone base to reset.
Clean the cordless handset, charger and telephone base
charging contacts each month with a pencil eraser or cloth.
A blinking CHARGE light is an indication that the battery is not
connected to the handset or is missing completely. Ensure that
the battery is installed properly.
I’ve set my LCD language to Spanish or French and I don’t know
how to change it back to English.
Press MENU/SELECT on your handset in idle mode. Then, on
the handset enter 364
#
. You hear a confirmation tone.
Common cure for electronic equipment.
If the telephone does not seem to be responding normally, try
putting the cordless handset in the charger. If it does not fix the
problem, do the following (in the order listed):
1. Disconnect the power to the telephone base.
2. Disconnect the cordless handset battery.
3. Wait a few minutes.
4. Connect power to the telephone base.
5. Completely remove the battery. Replace the battery and place
the cordless handset into the telephone base or charger.
6. Wait for the cordless handset to reestablish its connection
with the telephone base. Allow up to one minute for this to
take place.
•
•
•
•
•
19
To Next Page
Loading...
Need help?
General
