Multiple handset use
Intercom
Using the telephone base:
1. Press MENU/SELECT in idle mode to enter the main
menu. Press qCID or pDIR to scroll to Intercom, then
press MENU/SELECT.
If you have one handset and no other registered
devices, the telephone base shows
Calling HANDSET X.
If you have cordless headset(s)/speakerphone(s)
or more than one handset, the telephone base
shows INTERCOM TO: Use the dialing keys to eenter
a specific handset number (1-9 for handsets 1-9,
TONE followed by 0-2 for handsets 10-12, # for
a single headset/speakerphone, # followed by 1
or 2 for headset/speakerphone 1 or 2, or TONE
followed by # for all devices), or press qCID or pDIR to scroll to the
desired device and press MENU/SELECT. The telephone base shows
Calling HANDSET X or Calling all handsets.
The destination device(s) rings and shows BASE 0 is calling or
BASE 0 is calling all.
2. To answer the intercom call, press
PHONE/FLASH, /SPEAKERSPEAKER or any
dialing key (0-9, TONE , or
#
) on the destination handset. Both the base
and the handset now show Intercom.
3. To end the intercom call, one party presses OFF/CANCEL, or places the
handset back in the telephone base or charger; or presses CANCEL on the
telephone base. The other party hears four beeps. Both devices display The other party hears four beeps. Both devices display
Intercom ended.
NOTES:
Before the intercom call is answered, you can cancel it by pressing OFF/CANCEL on the
handset or CANCEL on the telephone base..
If the called device is not answered within 100 seconds, accessing the directory or caller ID log,
on a call, or out of range, the initiating device shows No answer. Try again.
To temporarily silence the intercom ringer, press OFF/CANCEL or MUTE/DELETE on the
handset, or press CANCEL or MUTE on the telephone base.
You can only use one pair of devices at a time to make intercom calls.
For cordless headsets and speakerphones, refer to the corresponding user’s manual on how
to answer and end an intercom call.
If a total of two cordless headset(s) and/or speakerphone(s) are registered to the telephone base,
they appear as HEADSET 1 and HEADSET 2 respectively in the intercom menu.
•
•
•
•
•
•
•
•
Calling
HANDSET X
Intercom
Base 0
is calling
47
To Next Page
Loading...
