Battery installation and charging
Getting started
7
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert the
supplied battery with
the label THIS SIDE UP
facing up, as indicated.
Step 2
Align the cover
flat against
the battery
compartment,
then slide it
upwards until it
clicks into place.
Step 3
Charge the handset by placing it
face forward in the telephone base
or charger. The CHARGE light on the
handset is on during charging.
CHARGE light
IMPORTANT INFORMATION
1. Use only the supplied rechargeable battery or replacement battery
(model BT183342/BT283342). To order, visit our website at
www.telephones.att.com or call 1 (800) 222-3111.
In Canada, dial 1 (866) 288-4268.
2. If you do not use the handset for a long time, disconnect and remove
the battery to prevent possible leakage.
After you install your telephone or power returns following a power
outage, the handset will prompt you to set the date and time. After
that, it will prompt if you want to set up the answering system
via voice guide (only for CL82114/CL82214/CL82314/CL82364/
CL82414/CL82464/CL82514 telephone system). Press MENU/SELECT
to start. For details, see the corresponding sections in the telephone
system’s user’s manual. To skip these settings, press
OFF/CANCEL
.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine