Insert the Button Label Sheet
7
8
9
To remove the clear plastic cover Place the button label sheet on
Replace the plastic cover.
from the phone, gently press down on
the center tab, then lift.
Test the Connection and Phone
10
11
To test the outside connection,
To test the intercom, press [
Intercom
].
press a line button. You should hear an
outside dial tone. Repeat for all lines.
Go to next page.
12
13
To test the telephone's lights and
ringer, press and hold [ # ] button for
5 seconds.
the phone. The holes on the sheet
should fit over the buttons.
You should hear a system dial tone.
Before releasing the [ #
] button,
lift the handset. All lights should light
and the ringer should sound. Hang up.
If you don't hear a dial tone for step
10 or 11, see chapter 7, "Trou-
bleshooting" (p. 7-2).
If the lights and/or ringer does not
respond properly, call the AT&T
Helpline at 1 800 628-2888.
Installing the Hardware
2-11
To Next Page
Loading...
