AT&T PC 6300 - Page 148

INSTALLATIONS
16. Verify the jumper's location: W2 connects pins 1 and 2, W4
connects pins 2 and 3, and W6 connects pins 2 and 3.
Location W3 does not have a jumper.
vary.
17. The jumper settings (SWl) for the 20-MB Seagate
ST-225 HDU with WD Controller are shown in Figure 3-34.
3-60
■n
14. Proceed to Step 19.
h
15. Verify that jumpers are present on Wl, W2, W4, and W6 on [ )
the WD Controller (Figure 3-32). ROM BIOS 1.43 or
higher are required for WD controller.
n,
u
n
Note: The physical locations of the jumpers may ^
•0
fl
0
n
n
n
n