AT&T PC 6300 - Page 232

DIAGNOSTICS
4i
Pressing the 2 key followed by the ENTER key takes you back to
the Operating System and the MS-DOS prompt is displayed. To
reenter the diagnostic routines, you have to input customer
followed by the ENTER key.
MENUB
The purpose of MENU B is to verify that the system has the
correct system configuration prior to performing any tests. A
menu similar to the one shown below is displayed after you have
pressed the key, 0 followed by the ENTER key at the end of
MENU A:
n..
n
1
THE INSTALLED HARDWARE IS:
1 - MAIN BOARD
3 - XXX KB MEMORY IXXX = Total System KAMI
4 -83 KEY KEYBOARD
5 - XXXX VIDEO SYSTEM (XXXX = COLOR or MONOCHROME)
6 - 1 PARALLEL PORTCS)
7 - 1 SERIAL PORTCS)
8 - X 48 TPI FLOPPY DISK DRIVECS) CX-1 or 2)
9 - X HDU DRIVE AND CONTROLLER CX-10 or 20 MB)
IS THE LIST OF HARDWARE CORRECT? Cy - YES,
NO)
If you press the y key followed by the ENTER key, MENU C is
displayed. In MENU C, you must indicate if all hardware is to be
tested or if specific hardware is to be tested.
)1
p
.! L
n
n
4-26
n
n
n
n