Synapse Installation Guide Back to Contents
Installation 44
Figure 24. ATA Analog Telephone Connections
Connecting a Fax Machine
To install a fax machine:
1. Remove the plastic covers from the FXS 1 or FXS 2 port to be used on the ATA.
2. Plug a telephone line from the fax machine into the ATA FXS 1 or FXS 2 port, as
shown in Figure 25.
3. Configure the fax connection in the WebUI.
For information on configuring the ATA to work with your fax machine, see the
Synapse Administrator’s Guide at
www.telephones.att.com/synapseguides.
Figure 25. ATA Fax Machine Installation
ATA
Analog Telephone/
Conference Phone
Analog Telephone/
Conference Phone
If you are connecting your fax machine to the ATA and your Synapse Dial Plan
uses a number for external line access, such as 9, you should inform users that
they need to dial this number when sending faxes.
To Next Page
Loading...
