12
Plug the large end of the headset base power adapter into a
power outlet not controlled by a wall switch.
Plug the end of the lifter control cable into the LIFTER jack at
the back of the headset base.
Use the attached fastener to bundle all line cords neatly.
Make sure the CORDED HANDSET
CONNECTED switch on the right side of the
headset base is set to YES.
Adjust the corded handset audio (see page
17) before you install the handset lifter on
the corded phone.
For instructions of installing the lifter, see
pages 18-20. For information about the
internal and auxiliary ring detectors, refer to pages 21-22.
5.
6.
7.
8.
9.
10.
Headset base and handset lifter installation
Option 1: Connect the headset to a corded phone (cont.)
8
To Next Page
Loading...
