Approximate installation time: 20 minutes
AT&T U-verse
®
TV
Wireless TV Receiver
UVE415_Wireless_TV_Install_Guide_Back_Release
UVE415_Wireless_TV_Install_Guide_Front_Release
Remote control
Ethernet cable (gray)
Wireless Access Point
power cord
Installation/product guides
Remote Control
User Guide
AT&T U-verse
Wireless TV Receiver
Manual
AT&T U-verse
Wireless TV Receiver
Installation Guide
Wireless Access
Point (WAP)
Product Manual
In the box:
Locate your existing Gateway
or Inside Unit and gather
materials needed for setup:
AT&T U-verse Wireless TV Receiver
The appearance of your receiver may differ
from the picture above.
TV receiver power cord
Customer-provided materials
A cable, such as HDMI, Composite, or other, is required
to connect the TV Receiver to your TV. This cable may
be present in your current setup, and can be reused.
However, if it is not, you will need to purchase this cable.
self- installation
guide
Get started
These instructions will guide you through the process of installing
your AT&T U-verse Wireless TV Receiver.
Wireless Access Point
(WAP)
OROR
Inside UnitGatewayGateway
To Next Page
