AT&T UNIX - Close Command

Using Office Commands
To clean up all open folders (including Filecabinet,
Wastebasket, Administration, and Floppydisk objects)
1 Open or resume the Office, a folder, the
F~lecabinet, or the Floppydisk object.
2 Select !Cleanup! from the Commands menu.
All open folders, Filecabinets, and Floppydisk objects
are closed and removed from the screen. The Office
becomes the current window. Any windows containing
application programs or the UNIX system are still open,
and they must be resumed and then exited before logging
out or shutting down the system.
Close Command
The Close command closes open objects. When you close
an object, the window for that object is closed and
removed from the screen. To issue the Close command,
you can use any of the following methods:
o Press the <Exit> key.
o Point to the [X] icon in the lower-left
corner of the window and press <Bl>.
o Select !Close! from the Commands menu.
o Press <Shift>-<Close>.
For more information on the various methods of entering
commands, see "Selecting Objects and Entering Commands"
in this section.
To close an object:
1
If the
object you want
to close is not the
active window,
resume it.
2
Press
<Exit> or point to the
[X]
icon and
press
<Bl>.
If the object you want to close is in a window in which
an application program is running, the program may
prompt you to save the file. See your application
manual for instructions.
3-56