AT&T UNIX - Create Command

Using Office Commands
To copy a folder:
1 Point to the name of the folder you want to
copy.
2 Press <Copy> or select I Copy I from the
Commands menu.
The message Open destination folder and touch
PASTE appears.
3 Open or resume the folder where you want to
place the copied folder.
4 Press [PASTE] or select IPastel from the
Commands menu.
The folder and its entire contents are copied into the
destination folder. If you want to give the copied
folder a new name, use the Rename command.
Create Command
The Create command displays a menu listing the objects
you can create; it then displays a form so you can name
the object you are creating.
The object you create is placed in the folder that is
active when you start the Create command. If you
create an object when the Office window is active, the
created object is placed in the Filecabinet. Two
exceptions are RS-232 Profiles and Modem Profiles,
which are placed in the Profiles folder in the
Filecabinet.
You can use either of these methods to enter the Create
command:
o Press <Creat>.
o Select ICreatel from the Commands menu.
For more information on the various methods of entering
commands, see "Selecting Objects and Entering Commands"
in this section.
3-61