AT&T UNIX - Page 212

Using Floppy Disks
After selecting FULLDISP, you see the WIDEDISP screen
key. To see a wide display of the MS-DOS directory:
o Select [WIDEDISP].
To view the contents of a file in the MS-DOS directory:
o Point to the name of the file and select
[OPEN] .
If the contents of the MS-DOS file take more than one
screen, use the space bar to view the next screen. You
can use the Ctrl-S key combination to pause the
scrolling and the Ctrl-Q key combination to start it
again. This function should be used only to verify a
file's contents, not to examine the information in
detail. You can use Shift-Exit key combination to
return to the MS-DOS Disk Read window.
To copy a file from the MS-DOS floppy disk directory
into your Filecabinet:
3-126
1 Point to the name of the file you want to
copy.
2 Select [COPY].
You see a window that displays a default file
name for the copied MS-DOS file. You can use
the supplied default file name or enter one
of your own. Keep the following in mind when
naming this copied file:
o If you select the default file name, the
file is copied into your Filecabinet. If
you want to move it to another folder, you
can do so later using the standard Move
command procedure. See the "Using Office
Commands" chapter in this section for more
information on the Move command.