AT&T UNIX - Restarting the Printer

Using Printers
Restarting the Prjnter
If you attempt to print when your printer is not
attached, you hear a beep and see the [!!] displayed on
the status line. Use the mouse pointer to point to the
[!!] and then press the left mouse button to display
the
system error message. The message informs you that
the printer cannot be accessed and that you must check
the power and the cable connection and restart the
printer.
To restart a printer:
1 Resume the Office window.
2 Point to !Printers!.
3 Press <Enter> or <B1>.
You see the Printers window.
4 Point to !Printer Restart! .
51 Office of tutor
[1J
.'
~
Administration Printer Queue
Clipboard
ID_mElI
F ilecabinet Printer Setup
Floppydisk
Ii
Preferences
tJ
~
Wastebasket
00 SJ
5 Press <Enter> or <B1>.
This command restarts the printer connected to your
UNIX PC, and you see the message: The printer is now
reset. The print job that was queued starts to print
or, if no print job was queued, the printer is ready to
print.
3-134