18
4.10 Warranty and Contact
All ATC products are guaranteed against any defect in materials or workmanship for
a period of two years from the date of purchase.Within this period we will supply
replacement parts free of charge provided that the failure was not caused by misuse,
accident or negligence.
Purchasers who complete and return the Warranty Card will have their
warranty period extended up to a period of six years from the date of
purchase.This guarantee does not limit statutory rights.
ATC can be contacted at:
Loudspeaker Technology Ltd, Gypsy Lane,Aston
Down, Stroud, Gloucestershire GL6 8HR, UK.
Telephone: 01285 760561
Fax: 01285 760683
Email: info@atc.gb.net
Website: www.atc.gb.net
SPA2-150 SPA2-200P
Specifications
ATC reserves the right to vary products and specifications without prior notice.Acoustic Transducer Co. is a trading name and ATC
is the registered trade mark of Loudspeaker Technology Ltd.
Output Power 150 Watts/Channel into 8 Ohms 200 Watts/Channel into 8 Ohms
Balanced Input Sensitivity 1V 1V
Balanced Input Impedance 10 kilohms 10 kilohms
Balanced Input C.M.R.R -90dB @ 1kHz -90dB @ 1kHz
Unbalanced Input Sensitivity 2V 2V
Unbalanced Input Impedance 10 kilohms 10 kilohms
Signal/Noise >110dB >110dB
Amplitude Response 5Hz - 200kHz ±0.1dB 5Hz - 200kHz ±0.1dB
Crosstalk
<
-105dB
<
-105dB
Distortion (at rated power)
<
-95dB
<
-95dB
Power Requirements: 100, 115, 230V factory set, 50/60Hz 100, 115, 230V factory set, 50/60Hz
Power Consumption 10 VA (Standby minimum) 10 VA (Standby minimum)
180 VA (Nominal) 180 VA (Nominal)
600 VA (Rated Output) 600 VA (Rated Output)
Dimensions (HxWxD) 146 x 440 x 426mm 130 x 428 x 325
Overall Weight 26kg (57.3lb) 22kg (48.5lb)
SPA2-150/200P
4.9 Care and Maintenance
High technology metal finishes are used in these
products.The surfaces are durable and with a little
care can be kept as good as new even under
conditions of heavy use. Normally a dry duster will
be all that is required to keep the finishes clean.
Heavier soiling of the aluminium can be cleaned
using a cloth slightly moistened with a non-
abrasive household cleaner - taking extreme care
not to allow any liquid to enter the units. Switch
off and disconnect the units from the mains power
before cleaning.
There are no components within the units that
would benefit from regular maintenance. There is
no requirement for any kind of routine service
work and there is no schedule for preventative
maintenance.
There are no user replaceable parts within the
units and in the unfortunate event of any
malfunction, repair should be referred to either
the supplying dealer or consultant, the relevant
distributor, or ATC.
To Next Page
Loading...
Need help?
General
