To Next Page

To Previous Page

B L A D E H A N D D R Y E R I N S T A L L A T I O N & U S E R M A N U A L | 3

p r e c a U t I o n s b e f o r e I n s t a l l I n g

Do not install the unit in the following locations; installation in these areas will cause the unit to

malfunction:

• Locationswheretheunitisunderdirectsunlightorwheredirectsunlightcanpassovertheunit.

• Locationswheretheunitcancomeintodirectcontactwithwater.

• Locationswherethereishighlevelsofhumidityandcondensation.

• Locationswherecorrosive,reductiveorneutralgasesarepresent.

• Locationswherethetemperaturecanfallbelow-10˚Corexceed40˚C.

• Locationsthatarelowerthan-20morhigherthan2000mabovesealevel.

Installation Location

• Installtheunitwhereiswillbeeasytouseasshowninthefigurebelow.

• Pleaseuseadedicatedfusedspurforeachhanddryer.

• ThehandDryermustbereliablyearthed.

• Thebottomoftheunitmustbeatleast150mmabovethefloortoallowforairflowintothehanddryer.

• Theleftsideoftheunitmustbeatleast150mmawayfromwallsasthepowerswitchisaccessed

from the left side of the hand dryer.

• Donotmountthehanddryerbehinddoorswheretheopeningofthedoormaydamagethedryer.

• TheMountingplatemustbemountedonacompletelyflatsurface.Ifthewallisnotflat,mountaflat

timber or board on the wall to give a completely flat surface to mount the hand dryer on to.

• Donotinstallthehanddryerwiththepowerconnected;thedryermustbeconnectedbyaqualified

electrician when being installed

ATC GS-2006H SLV User Manual

Questions and Answers: