Honda Fuel Injection Adapter
INSTRUCTIONS:
1. Attach gauge to the hose assembly that
has the female pipe thread, using pipe
sealer. (Assembly C)
2. Hand-tighten large male end of Honda
Fuel Injection Adapter onto the female
end of the gauge hose assembly.
3. Remove the screw from the test port on
the bolt holding the banjo tting onto the
fuel lter. (Fuel lter is under the hood,
just in front of the re wall, on the
passenger side.)
4. Screw gauge hose assembly hand tight
into where screw was removed.
5. Start engine and measure fuel pressure.
6. To disconnect , wrap connection in a rag.
Do not disconnect over a hot engine or
manifold.
7. Replace and tighten the screw to the
banjo bolt. Check for leaks.
042-42130 - Rev B
To Next Page
Loading...
