INSTRUCTIONS:
1. Insert the T-handle Spiral Probe Tool into the punctured tread at a slight angle then straighten the
tool and push the tapered shaft in and out of the hole several times to expand and enlarge the
broken steel cord.
2. Prepare T-handle Insert Tool for insertion by first dipping the tip into the lubricant.
2-1 Next insert the tire repair string (tire plug) through the hole in the installer tool.
2-2 Make sure that the tire repair string (tire plug) is fairly well centered in the shaft prior to installation.
3. Insert the tire repair string (tire plug) into the hole and push straight down on the insert tool handle
till the ends of the tire repair string (tire plug) are sticking out of the tire 1/2” to 1”.
4. Pull the T-handle Insert Tool straight out of the hole till the tip is just even with the tire tread then cut
the exposed tire plug ends just slightly above the tread and remove the installation tool.
5. After airing up the tire to its correct tire pressure spray the tire repaired area with a soapy water and
check that the puncture is sealed and not leaking.
To Next Page
Loading...
