ATEQ F670 - Page 37

QSG_F670_363.00_EN_01_2021-02-09
37/42
PARAMETERS menu
Use this menu to configure the measurement cycle associated to each test program.
Default parameters of the LEAK type tests.
Label
Parameter
Description
COUPL. A or COUPL. B
Coupling time
Required times when instrument manage
automatic jigs
FILL TIME
Fill time
Time to pressurise the part under test
STAB TIME
Stabilization time
Time to stabilize the pressure on the test and
reference parts
TEST TIME
Test time
Time for leak measurement
DUMP TIME
Dump time
Time to vent the part to atmosphere
Press. UNIT
Pressure units
Pressure unit (bar, mbar, PSI, Pa, kPa, MPa)
Max FILL
Maximum fill pressure
Maximum level of the fill pressure
Min FILL
Minimum fill pressure
Minimum level of the fill pressure
LeakUnit
Reject unit
Measurement units
Test FAIL
Test fail
Upper leak rate limit for the test part. Above this limit,
the part is considered as defective.
Ref. FAIL
Reference fail
Reference part reject level
FUNCTIONS
Functions
Access to additional functions
Some parameters are displayed when specific functions are activated.
Label
Parameter
Description
INTER-CYCLE
Inter cycle time
Time between two automatically chained
programs (Sequence function)
Max PreFILL
Max pre fill pressure
Maximum level of the pre fill pressure (Pre fill
function)
OFFSET
Leak offset
Leak offset value
PRE DUMP
Pre dump time
Time to dump the part under test (Pre fill
function)
PRE-FILL
Pre fill time
Time to pressurise the part under test (Pre fill
function)
REJECT CALC.
Reject calculation
Define raw unit to calculate flow unit (Flow unit)
Set FILL
Set fill
Fill pressure instruction (Fill function or
electronic pressure regulator)
Set PreFILL
Pre fill pressure
Pre fill pressure instruction (Pre fill function)
VOLUME
Test volume
Complete volume of the test part (Flow unit)
Volume UNIT
Volume unit
Volume unit of the test part (Flow unit)