TPMS TOOL user guide
UM-36600A-U User manual ATEQ VT56 Page 12/42
1.5. REPROGRAM ECU THROUGH OBD2 PORT
After all sensor IDs is read and displayed on the tool, connect
OBD module to the tool. The OBDII icon appears on the header
to confirm.
Plug OBD2 module to the OBD2 port on vehicle, and turn
ignition on.
Select the OBD
button
.
= Continue
= Previous
Note: Keep the
engine OFF.
= Continue
= Previous
= Continue
= Previous
The transfer begins.
The following
messages appear
briefly.
CONNECTED
TRANSFER OK
VERIFY OK
SUCCESSFUL
TRANSFER
= Previous
The data transfer to the ECU is complete. OBD2 module must be unplugged from the DLC
connector.
To Next Page
Loading...