TPMS TOOL user guide
UM-36600A-U User manual ATEQ VT56 Page 32/42
6.2. "CREATE SENSOR ID" SECTION
This section is to create a MMY specific sensor if the "old" sensor can't be cloned. The
new sensor ID(s) is generated randomly by the tool, and may not be the same as the
original one. Perform TPMS reset, see section 2, is required when replacing new sensors.
Scroll Right and left
to select the
CREATE option.
= Continue
= Previous
Position the sensor
in front of the tool
antenna to send ID
to the new sensor.
= Continue
= Home
Wait a few seconds.
The tool verifies the
ID uploaded.
To Next Page
Loading...