ATEQ VT15 - VT15 Operation and Maintenance; Positioning and Activation; Cycle Control and Duration; Battery Replacement and Disposal

VT15 V2
1 - Put the VT15 in front of the tire
near the sensor
2 - Start the cycle by pressing and
releasing the left key (TX1)
1 to 50 seconds
3 - The result can be immediately to
50 seconds
4 - Stop the cycle by pressing the right
key (TX2)
* The cycle stops itself after 50 seconds
Low Bat
light on
(TX2)
Replace the battery by a similar
Do not dispose of the battery
to the dustbin*
The cros
sed-out wheeled dustbin means that within the EU the product must be
taken to separate collection at the product end-of life.
For all updates, manuals and information see the following link:
www.ateq-tpms.com