ATEQ VT30 - Powering On and Vehicle Selection; Power On Device; Vehicle Selection; Sensor Triggering Process

2 | ATEQ VT30 Quick Start User Manual
3- Position the VT30 on the sidewall
above the valve.
(Position 180 degrees from the
valve for Ford band sensors.)
1- Press and hold the power
button until the VT30 powers up.
2- Select your vehicle and press
enter.
4- Start the sensor trigger cycle.
ATEQ VT30 Quick Start User Manual | 3
5- Wait for the sensor to be triggered.
6- Sensor information displays on the
screen.
LOW BATTERY POWER signal ON Replace the 9V battery by opening
the cover at the back of the VT30.