8 PARTIAL COUNTER RESET
Proceed as follow:
Push briefly S button: the display shows tot for 3-4 seconds and, after this, the total working hours value
for around 8 seconds.
During the visualization, push S button briefly: display shows Par for around 3 seconds and, after this, the
partial working hours for around 8 seconds.
Keep pushing S button until you see ” - - - - ” blinking.
Release S button: display will auto-switch off after a few seconds and the partial hours counter is
resetted.
9 WARNINGS
DON’T USE HIGH-PRESSURE WASHER
IN CASE OF LOW BATTERY THE HOUR METER STOPS AND THE DISPLAY WILL
START BLINKING