INSTALLING AN OTA UPDATE
Make sure that your scooter is charged over 40% and it is
recommended that the scooter is connected to the charger
to start the installation.
You can start installing by choosing ‘Update Now’ and
then following the instructions on the dashboard.
Alternatively, you can choose to do it at a later time.
Default installation time - 3 AM (this is only if the charge
conditions mentioned above are met.)
Please note, you will not be able to use your scooter
while the update is being installed.
CHARGING AT ATHER GRID POINTS
To locate an Ather Grid® public charging point, go to
the app or Navigation Screen where you’d be able to
locate the points live on the Ather Grid.
18
To Next Page
Loading...
