Manual, F/T Sensor, Data Acquisition (DAQ) Systems
Document #9620-05-DAQ.indd-20
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati-ia.com • Email: info@ati-ia.com
52
5. Look into the front of the IFPSMC box to verify there are no jumpers installed for
the IFPS card you are installing. Refer to Figure 4.22.
a. If the corresponding 12 pin jumper is installed for the slot to be populated, it
must be removed. Proceed to step 6.
b. If the 12 pin jumpers are not installed proceed to step 12.
Figure 4.22—Removing 12 Pin Jumpers on the IFPSMC Backplane
JP908
JP904
JP905
JP913JP912
JP907
JP906
JP909
JP910JP911
If installing an IFPS Card in Slot 1 (TC1)
Remove Jumpers on JP910 and JP911
If installing an IFPS Card in Slot 2 (TC2)
Slot 2 has no associated Jumpers
If installing an IFPS Card in Slot 3 (TC3)
Remove Jumpers on JP912 and JP913
If installing an IFPS Card in Slot 4 (TC4)
Remove Jumpers on JP904 and JP905
If installing an IFPS Card in Slot 5 (TC5)
Remove Jumpers on JP906 and JP907
If installing an IFPS Card in Slot 6 (TC6)
Remove Jumpers on JP908 and JP909
6. Disconnect all the IFPS cards from the backplane by rmly holding the top of the
IFPSMC box and simultaneously pulling the two plastic loops attached to each
board. Pull each board out about 1/2” to disconnect from the backplane. Refer to
Figure 4.21.
7. Remove the (4) M4 pan head screws from the back panel using a Phillips head
screw driver.
8. Carefully remove the back panel with the backplane board attached.
9. Remove the 12 pin jumpers from the backplane for the IFPS card being installed.
Refer to Figure 4.22.
NOTICE: The jumpers allow access to channels not used by unpopulated
IFPS cards through the connector 0 and 1 from user connectors on the back
of the IFPSMC box. Refer to Table 4.11 and Table 4.12 for more information.
You must remove the jumpers associated with the slot for the IFPS card
being installed, refer to Figure 4.22. If access to extra signals is not desired,
you may safely remove all 10 of the 12 pin jumpers to simplify future IFPS
card installation.
To Next Page
Loading...
