positive lead.
1. Negative battery lead (black)
2. Positive battery lead (red)
4. Pull the battery out of its compartment.
To charge the battery
Have a dealer charge the battery as soon as possible if it seems
to have discharged. Keep in mind that the battery tends to
discharge more quickly if the ATV is equipped with optional
electrical accessories.
NOTICE
To charge a battery, a special (constant-voltage) battery
charger is required. Using a conventional battery charger
will damage the battery.
To store the battery
● If the ATV will not be used for more than one month, remove
the battery, fully charge it, and then place it in a cool, dry
place.
● If the battery will be stored for more than two months, check
it at least once a month and fully charge it if necessary.
NOTICE
Always keep the battery charged. Storing a discharged
battery can cause permanent battery damage.
To install the battery
TIP
Be sure the battery is fully charged.
1. Place the battery in its compartment.
2. Connect the positive battery lead first, then connect the
negative battery lead by installing their bolt. NOTICE:
When installing the battery, the main switch must be
off, and the positive lead must be connected before
the negative lead.
To Next Page
Loading...