To set up a multi-monitor display 23
To configure your primary display
1 Navigate to the Control Panel and choose Display, or right-click on
the desktop and choose Properties.
2 Choose the Settings tab and select the screen resolution and color
depth that best suit your requirements and your monitor’s
performance.
3 Click Advanced and select the Monitor tab.
4 Choose a refresh rate from the drop-down list.
5 Click OK to return to the desktop.
To set up a multi-monitor display
1 From the Start menu click Control Panel, then Display. Click the
Settings tab to access the basic multi-monitor configuration settings.
2 Select the Monitor icon identified by the number 2.
3 Click Extend my Windows desktop onto this monitor.
4 Set the Screen Resolution and Color Quality as appropriate for the
second monitor. Click Apply or OK to apply these new values.
• Refer to your Windows® online help and documentation for
further information on using the Settings tab.
Note: When you use multiple monitors with your Radeon® X1300
Series card, one monitor will always be Primary. Any additional
monitors will be designated as Secondary.
Note: You can also enable multiple monitors using ATI’s Catalyst®
Control Center.
Reinstalling Drivers
You can install new drivers or reinstall existing drivers if there was a
Windows® conflict.
Reinstall the drivers at any time using the ATISETUP utility located on the
ATI Installation CD-ROM. The ATISETUP utility will start automatically
if you insert the ATI Installation CD-ROM into your optical drive after the
operating system has started.
To manually reinstall drivers
To Next Page
Loading...
