WWW.ATKBINDINGS.COM | PROUDLY MADE IN ITALY SINCE 2007 41
Move the boot tip towards the toe part, matching the front TECH insert seats with the toe hooking pins
(PICTURE 20). From this position, vertically push on the toe part to step in. (PICTURE 21/22). Rotate a
few times the boot in order to check the proper boot-binding coupling, as shown at PICTURE 22.
Check that the front locking lever is in downhill skiing mode (SKI), as clearly shown at PICTURE 23. The
marked line should match with the “SKI” lines. If not like that, slightly push on the front locking lever in
order to obtain the proper position, as shown at PICTURE 23.
To Next Page
Loading...
