WWW.ATKBINDINGS.COM | PROUDLY MADE IN ITALY SINCE 2007 25
WARNING! DANGER!
Before proceeding with any operation regarding the installation or use of the product, please make sure
that you have fully understood what is written and explained in this guidebook.
In case of any doubts and/or uncertainties, please contact ATK® at the e-mail address
"customercare@atkbindings.com" for integrations or clarifications regarding any content of the manual.
WARNING! DANGER!
This binding model
DOES NOT COMPLY WITH ANY DIN/ISO SAFETY STANDARD NOR ANY SAFETY CERTIFICATION.
In particular, this binding does not comply with DIN/ISO 11088 and/or DIN/ISO 13992 safety standards.
Therefore, the release systems offered by the binding could fail in releasing the boot when necessary
and/or expected with a consequent danger for the User’s safety.
2| GENERAL WARNINGS AND RECOMMENDATIONS
WARNING! DANGER!
This binding is conceived, developed and produced for Ski-Touring activities. The high performances
and the extreme lightness required to this product can influence and/or reduce the safety features of
the product itself, including the quality or repeatability of the boot release in the event of a fall.
This binding can only be used in combination with TOURING boots, provided with standard “tech”
inserts and general geometries that comply with market standards.
This binding heel part offers adjustable release systems with values in between 5 to 10. Calibrating the
most suitable release value for the User’s characteristics may reduce the risk of injuries to the inferior
limbs under the femur.
The user, by removing the "SEAL OF LIABILITY" from the binding, consciously assumes all the
responsibility raising from the use of this product, and therefore releases ATK® from any damage
caused to himself and/or third parties during the use of the product.
To Next Page
Loading...