Atlanta 60 Series - User Manual

BWL 300-01e
Operating and Maintenance Instructions
4100-001-12.93
Dept. TB / Gm Page 1 40
Rev. Index E Name Steinbach 17.06.05
Date 20.01.10
Type 60 and 61 Screw-jack Gearboxes
Released
BWL_300_Erweiterung_englisch_Speicherstand.DOC
Operating and Maintenance Instructions
for
ATLANTA High-performance and Standard
Screw-jack Gearboxes
Series 60 and 61
ATLANTA Antriebssysteme
E.Seidenspinner GmbH & Co. KG
Carl-Benz-Strasse 16
D-74321 Bietigheim-Bissingen
Phone: +49 (0)7142-7001-0
Telefax: +49 (0)7142-7001-153 (Sales Dept.: Systems)
http://www.atlantagmbh.de
ATLANTA does not assume liability for any damage to the transmission or any re-
sulting consequential damage, if these instructions are not observed.

Summary

2. Proper application

4. Preparing the installation

5. Mounting

5.12. Mounting the motor:

Guidance on mounting and attaching the motor to the gearbox.

6. Electrical start-up:

7. Mechanical start-up:

7.1. Test-run of the screw-jack gearbox before the installation:

7.2. Installation of the screw-jack gearbox in the equipment:

Steps for installing the screw-jack gearbox into the overall equipment.

7.3. Lubricating instructions for screw-jack gearboxes:

Detailed guide on lubricating screw-jack gearboxes for optimal performance.

7.4. Installation of the screw-jack gearbox with non-rotating spindle in the system:

7.5. Installation of the screw-jack gearbox with rotating spindle in the system:

8. Operation

9. Maintenance

9.3. Changing the gearbox lubricant:

Step-by-step guide for changing the gearbox lubricant, including oil and grease types.

9.4. Measuring the wear of the trapezoidal-thread nut:

Methods for measuring wear on the trapezoidal-thread nut.

9.5. Replacing the trapezoidal-thread nut:

Instructions on how to replace the trapezoidal-thread nut.

9.7. Replacing the spindle:

Detailed steps for replacing the spindle in gear units with non-rotating spindles.

Gear unit with rotating spindle and lock-nut fastening (Part number: 60 2 x xxx):

Procedure for spindle replacement in rotating spindle gear units with lock-nut fastening.

Gear unit with rotating spindle and key assembly (Part numbers: 60 3 x xxx und 61 2 x xxx):

Procedure for spindle replacement in rotating spindle gear units with key assembly.

12. Motor connecting diagram for three-phase motor without brake - with limit switches on the protective tube for gear units with non-rotating spindle:

13. Motor connecting diagram for three-phase motor with brake:

Atlanta 60 Series Specifications

General

Brand	Atlanta
Model	60 Series
Category	Jacks
Language	English