Rev.0 13/01/2020
Operator Panel | TURNTABLE - MAST
18
2.2
display is used for showing the manual controls. To execute
the manual command, use the buttons
F+
and
F-
command and press the button indicated in the list below:
C0 Button
(B)
Clockwise arm rotation
C0 Button
(G)
Counterclockwise rotation arm (only on Station)
C1 Button
(B)
Carriage up
C1 Button
(G)
Carriage down
C2 Button
(B)
Presser up
C2 Button
(G)
Presser down
C3 Button
(B)
Rotating roller conveyor, loads pallets up to the wrapping position
C3 Button
(G)
Rotating roller conveyor, unloads pallets
C4 Button
(B)
Clamp closing
C4 Button
(G)
Clamp opening
C5 Button
(B)
Lift connector
C5 Button
(G)
Film cutting/sealing test sequence (the alarms are disabled; allows
checking the position of the sensors and the valve adjustments)
C6 Button
(B)
Lift creasing carriage
C6 Button
(G)
Lower creasing carriage
C7 Button
(B)
Roller conveyors forward, aligns the pallets with the first available
photocells
C7 Button
(G)
Roller conveyors forward, unloads the pallets from the line (when
applicable)
C8 Button
(B)
Cutting actuation
To Next Page
Loading...
