The standard 15mm kit comprises:
1 pair of standard inlet hoses (white)
1 white overflow hose (1.5m)
3m red drain hose
1 x ¾” overflow nut
1 x ¾” flexible hose adaptor elbow
1 Transformer
1 Water Hardness test kit
3 x ¾” washers and 1 x ¾” screen washer
1 set of bypass valves
1 x ½” to
3
/
8
”speedfit drain adaptor
1 drain saddle clamp
The Hi-flo 22mm kit comprises:
1 pair of Hi-flo hoses (black)
1 white overflow hose (1.5m)
3m red drain hose
1 x ¾” overflow nut
1 x ¾” flexible hose adaptor elbow
1 Transformer
1 Water Hardness test kit
3 x ¾” washers and 1 x ¾” screen washer
1 set of bypass valves
1 x ½” to
3
/
8
”speedfit drain adaptor
1 drain saddle clamp
2 x 19mm straight connectors
4 x ¾” nuts
4 x jubilee clips
2 x 19mm bent connectors
I
Congratulations on your new purchase. Atlantis Water Softeners are built with pride to the highest
possible standards. Please take care with the installation to ensure trouble free operation. If you have
any queries please feel free to contact our Technical Department. We have many years experience and
our technical staff will be pleased to advise you on 01440 761500.
BEFORE INSTALLATION
Test the water pressure (see Item 1). Locate the rising main, drain facilities and electricity supply. Ensure
there is only one rising main. Always observe the Water bylaws. Allow room for salt filling, maintenance
etc. If you are connecting to a tank fed system ensure that the float valve opens fully. If in doubt fit a
float valve with a delayed fill action, such as the Fluidmaster Pro75B.
FIND THE BEST LOCATION
The softener requires:
A mains water supply, a power supply, a drain outlet & overflow.
If possible site the softener near to the rising main. Make provision for any hard water draw off points,
for example outside taps and drinking water taps. IMPORTANT: Make sure that the softener and pipe
work is not subjected to freezing or unduly high temperatures. If installing above ground level we
recommend that ¾” rigid overflow pipe is used.
INLET & OUTLET CONNECTIONS
Your softener will have either a standard or a high flow kit, depending upon what was ordered. The
standard 15mm kit is for use on traditional plumbing systems with a 15mm main, and a storage tank in
the loft. The Hi-flo 22mm kit is for us on mega-flow type unvented systems with a 22mm main.
DRINKING WATER
A tap to be used for drinking water must be left on the hard water supply.
INSTALLATION KIT
To Next Page
Need help?
General
