Starting the engine, Hatz manual start
1. Pull up the automatic decompression device to
start position.
2. Move the throttle control handle to idling position.
For non EPA throttle control:
Move the throttle control handle to half throttle,
position (A).
For EPA throttle control:
Pull up the stop (B) to release the throttle control
handle. Move the throttle control handle to half
throttle, position (A).
NOTICE The EPA throttle control has three
fixed positions. Make sure the throttle control
handle is in a fixed position.
3. Rotate the start handle until the engine resists.
4. Allow the engine to idle for a few minutes.
19© 2016 Construction Tools EOOD | No. 9800 1721 01 | 2016-04-07
Original instructions
Safety and operating instructionsLG 504
To Next Page
Loading...
