Atlas Copco LG 504 - Checking bolted joint; Checking the battery; Hydraulic system, checking the hydraulic oil level; Every 500 hours of operation (yearly)

Checking bolted joint
Check and if necessary tighten screws and nuts.
Checking the battery
1. Disconnect the battery cables (A).
2. Check that the battery (B) is not damaged.
3. Clean the battery terminals (C).
4. Refit the battery cables (A).
Hydraulic system, checking the hydraulic oil
level
1. Check the hydraulic oil level by using the dipstick
(A).
2. Fill up with hydraulic oil if necessary, see chapter
"Hydraulic system, changing the hydraulic oil".
Every 500 hours of operation
(yearly)
Maintenance routines:
♦
Adjust valve head clearance for intake and exhaust
valves. See the engine manual for more
information.
♦
Clean and check the fuel filter and fuel tank. See
the engine manual for more information.
♦
Replace the air filter.
♦
Clean the engine's cooling flanges. See the engine
manual for more information.
♦
Check the fuel injection pump. See the engine
manual for more information.
♦
Check the fuel injection nozzle. See the engine
manual for more information.
♦
Change the oil in the engine. See the engine
manual for more information.
♦
Drain the fuel system of water. See the engine
manual for more information.
♦
Replace the fuel filter. See the engine manual for
more information.
♦
Change the oil filter. See the engine manual for
more information.
♦
Changing the oil in the eccentric element.
♦
Hydraulic system, changing the hydraulic oil.
29© 2016 Construction Tools EOOD | No. 9800 1721 01 | 2016-04-07
Original instructions
Safety and operating instructionsLG 504