Instruction manual
Preliminary 25
Restarting before the parameter is back within its limits is
impossible, because of the parameter check in the cranking
procedure.
Emergency stop
When an emergency stop button is hit, this message appears on the
screen.
Until the emergency stop button is reset, the operator cannot do
anything.
When the emergency stop button is reset, the operator can proceed
to the Ready for Start status or to the Process Info status.
Warnings
When a warning is generated, the warning will appear on the screen
of the UI, and the user is prompted to a malfunction or a potential
shutdown.
There are two kinds of warnings: Process warnings and Apparatus
warnings.
– Process warnings do not have any effect on the CCM’s operation.
They are generated when a measured value has exceeded its limits.
These Process warnings are: fuel level warning, engine oil level
warning, compressor oil level warning and discharge temperature
warning.
– During operation, all sensors, some outputs and the communication
lines are continuously checked for failures. When such a failure
occurs, the CCM will generate an Apparatus warning. Some errors
can cause the CCM to go to the Shutdown status (if running) or to
the Start Failure status (if in Permissive Start status).
*Note: See “Cooling down” on page 24.
Apparatus warnings Effect
Fuel Level Sensor Shutdown
Air Discharge Pressure Sensor Shutdown
Compressor Oil Pressure Sensor Shutdown
LP Element Temperature Sensor Shutdown
MP Element Temperature Sensor Shutdown
Loading Valve Output Shutdown
ECM Communication Link Shutdown
CAN Communication Link Shutdown
Starter Relay Shutdown
Compressor Intercooler Pressure 1 Sensor Warning
Compressor Intercooler Pressure 2 Sensor Warning
Compressor Oil Temperature Sensor Warning
Air Discharge Temperature Sensor Warning
Air Inlet Temperature Sensor Warning
Oil Level Maintainer Valve Output Warning
Flasher Lights Output Warning
Horn Output Warning
Blow-off Valve Output Warning
EEPROM Warning
Default Mode Warning
Process warnings Effect
Fuel Level Shutdown
Engine Oil Level Too Low Shutdown
Engine Oil Overfill Shutdown
LP Element Temperature Shutdown
MP Element Temperature Shutdown
Fuel Level Warning
Engine Oil Level Low Warning
Air Discharge Temperature Warning
Autostart Pressure higher than Setpressure Warning
Battery Voltage Low Warning
Battery Not Charging Warning
Engine warnings Effect
Engine Coolant Level Sensor Failure Shutdown
Engine Coolant Temp. Sensor Failure Shutdown
Engine Oil Temperature Sensor Failure Warning
Engine Fuel Temperature Sensor Failure Shutdown
Engine Air Inlet Temp. Sensor Failure Warning
Engine Turbo Boost Press. Sensor Failure Warning
Engine Oil Pressure Sensor Failure Shutdown
Engine Fuel Pressure Sensor Failure Shutdown
Engine Coolant Level Low Shutdown
Engine Coolant Temperature Too High Cooldown*
Engine Air Inlet Temperature High Warning
Engine Oil Pressure Too Low Shutdown
Turbo Boost Pressure High Warning
Engine Fuel Pressure Too Low Shutdown
Engine Injector X Failure Shutdown
Fuel Temperature Too High Shutdown
Engine RPM Sensor Failure Shutdown
To Next Page
Loading...
